SecurityMan PIR-SD Bedienungsanleitung PDF herunterladen (Seite 19)

1. Remove the SD card from the PIR-SD by gently pushing on the SD

card allowing it to pop out from the SD card slot.

2. Insert the SD card into an SD card reader (not included) connected

to your PC (your PC should load the SD card as a new Removable Drive).

3. When prompted, select the “Open folder to view ﬁles” option to

view its contents, you should see two folders labeled SYSTEM

and VIDEO.

Open the VIDEO folder to view a list of all the recorded events. Once

inside the video folder you can double-click any of the recorded AVI ﬁles

and the video will begin playing in your default AVI media player.

NOTE: To playback video footages, we recommend to remove the

SD card from the PIR-SD to playback. Using method 1 to connect the

PIR-SD via USB cable for playback is strongly NOT recommended.

Once the PIR-SD is powered on, if for any reasons the power were to

be unplugged from the PIR-SD, the Date and Time will auto reset to

default date/time. When this occurs, please remember to setup the

Date and Time before the next operation.

Integrating with Air-Alarm Series

To f ully integrate the PIR-SD system with the Air-Alarm Host series,

there are three components that needs to be added. Adding the PIR-SD

remote control (Not a must), the PIR-SD motion detection sensor, and the

video recording (on/off) as shown below. To avoid using multiple remote

controls when integrating the PIR-SD to the Air-Alarm host series, please

add the PIR-SD remote control to the Air-Alarm host series or vice versa.

Adding PIR-SD Remote to the Alarm Host

Step 1: Press PRGM/SET + Password (system default 888)+ENT+70+

ENT+00+ENT [the “ /Learn” light will appear solid blue/red].

Step2: Press any 1 of the 4 buttons on the PIR-SD remote twice

consecutively to add.

1 2 ... 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

SecurityMan PIR-SD Bedienungsanleitung Seite 19